Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
whitey72mg
Freshman Member
Offline
I need to replace the hood release cable. Any pointers on how to do this?
-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hood release
- Thread starter whitey72mg
- Start date
Share this page
Trevor Jessie
Yoda
Offline
It is a good job to do when the engine is out.
Do you need to replace just the inner cable, or the whole shooting match.
Do you need to replace just the inner cable, or the whole shooting match.
OP
whitey72mg
Freshman Member
Offline
I think I need to replace the entire setup. I won't have the engine out anytime soon. Can it be done otherwise?
Trevor Jessie
Yoda
Offline
It can be done, but it is difficult to reach the nut on back side of the knob assembly. I do not remember if it is possible to get to it from the underside of the car, but I seem to remember replacing mine was not too bad from the top side when I had the carbs and manifold removed.