Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Replaced my starter with a hi-torque starter. Now I have a question on wiring. If I use the following from Masters' "bible", where would the white/orange (seat belt and bulb test) wires go? I assume the white/red goes to the spade connector and the white/yellow ballast wire goes to a small screw on the starter. Anyone have any thoughts on this?....thanks!
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
TR6 Hi Torque starter wiring - '76 TR6
- Thread starter billh1963
- Start date
Share this page
poolboy
Yoda
Offline
My interpretation is that the W/O wires need to be connected to the terminal that has voltage ONLY when the starter is operating..not hot when the engine is running and not hot when the ignition key is just in the ON position...only hot when the starter is spinning. You find that terminal and I think you'll find the proper spot for the W/O wires
Chrisc9
Freshman Member
Offline
What was the final arrangement?