Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
My horn, interior light, flasher and radio have stopped working in my Triumph GT6 MKIII. Checked the bottom fuse (Of the 3 in the original fuse box). It was blown. I changed it and it promptly went again. I took my dash out and checked for dodgy wires and changed a connector on the flasher unit. I put another fuse in and it didn't blow but none of the above instruments would still not work. Help.........Any suggestions welcome
-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
GT6 Help electrical guru needed
- Thread starter Eldwick
- Start date
Share this page
Offline
Checked wires, changed flasher connection, new fuse, no short - but devices still not working. I'm thinking a ground strap has come loose.
Do you have a wiring diagram which shows ground wire/straps? I've attached a few which might help. Sorry but I'm not a GT6 owner.
Tom M.
Do you have a wiring diagram which shows ground wire/straps? I've attached a few which might help. Sorry but I'm not a GT6 owner.
Tom M.
Attachments
Offline
Looks like the top fuse supplies power to all the things not working. Use a 12V test light to see if power is going to that fuse from the brown wire at one end. It should be "hot" with ignition on or off. Then check the other side of the fuse to see if voltage is getting through.
Offline
Electrical troubleshooting is just a matter of following the clues and eliminating possibilities until you locate the problem. If you replaced the fuse and the components that are powered by it are not working, you almost certainly are losing power at the block--that's the only place that's common to all of them. It's very likely that something in the connection to the fuse block is loose and shorting somewhere. Depending on the design of the block, it might be on the underside where you can't see it.
Light fixtures are another common location for shorts. There are always spots where wires can fray easily or there is little clearance between parts that must stay separated.
Light fixtures are another common location for shorts. There are always spots where wires can fray easily or there is little clearance between parts that must stay separated.