Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
OP
spiny
Member
Offline
Re: Hello, possible stupid question .... crank pu
[ QUOTE ]
Another way that works to free and engine pretty well (and its much easire to free up before tearing the engine down and driving the piton out with a hammer) it to cut the threads off a spark plug and then tap that threaded part out with an 1/8" pipe tap and screw a grease fitting into it. then buy a 99cent tube of grease from walmart and use your grease gun to move the piston. It applies plenty of pressure and it is spread out across the piston. I have used this many times, no hammering no straining.
[/ QUOTE ]
yeah, did that on the front calipers of my VW bus a few years ago, it's a good tip!
[ QUOTE ]
Another way that works to free and engine pretty well (and its much easire to free up before tearing the engine down and driving the piton out with a hammer) it to cut the threads off a spark plug and then tap that threaded part out with an 1/8" pipe tap and screw a grease fitting into it. then buy a 99cent tube of grease from walmart and use your grease gun to move the piston. It applies plenty of pressure and it is spread out across the piston. I have used this many times, no hammering no straining.
[/ QUOTE ]
yeah, did that on the front calipers of my VW bus a few years ago, it's a good tip!
