Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Rob Glasgow
Jedi Knight
Offline
I recently purchased a new heater control panel for my BT7 from Moss. When I tried to install it I noticed it had a dip in the top edge where the panel meets the dash, instead of being flat like the original panel. This left a small gap between the dash and the top of the panel. Moss sent another but it had the same concave top surface as the first.
I called Moss and had them check several other panels and all of them had the dip.
My orginal fits the dash perfectly with no gap. Anyone else run into this problem? Is there another source that fits better?
I called Moss and had them check several other panels and all of them had the dip.
My orginal fits the dash perfectly with no gap. Anyone else run into this problem? Is there another source that fits better?
