Received NOS set of Vandervell main bearings, but surface finish color has some dull grey areas & the remainder typical semi shiny silver. All were well coated with packing grease, so I'm not sure if this is a concern. I can't feel any ridge or change in surface finish when running finger from dull silver surface to shiny.
Other concern is that all main caps are all the same width accept one. The rear main area can accept a wider Cap, but maybe this is a packing error, that there should have been two wider Caps included for the rear.
Any one with experience with both questions?
Other concern is that all main caps are all the same width accept one. The rear main area can accept a wider Cap, but maybe this is a packing error, that there should have been two wider Caps included for the rear.
Any one with experience with both questions?