• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

have VROOM again on engine rebuild, breakin check?

Share this page

R

recordsj

Jedi Warrior
Offline
Finished rebuild of engine and car drives again! We have vroom-vroom again! Now I am able to be on the road for at least most of the summer here in the pacific NW.

Should I be checking torque on the head studs after certain number of miles from the rebuild? Anything else I should look for/check?
 
Re: have VROOM again on engine rebuild, questions

I've heard 500 miles as a common benchmark, but get some other opinions (ideally from Hap) as well.
 
Re: have VROOM again on engine rebuild, questions

Tom_Lynch said:
I've heard 500 miles as a common benchmark, but get some other opinions (ideally from Hap) as well.
Click to expand...

Thanks.

I am looking for a list of stuff to check. I figure check the valve lash, drain the oil and replace the filter,... anything else? What about checking head stud torque?
 
Re: have VROOM again on engine rebuild, questions

Just don't overtighten. It's easy to do. You don't want to snap a head stud at this point.
 
Re: have VROOM again on engine rebuild, questions

Jim_Gruber said:
Just don't overtighten. It's easy to do. You don't want to snap a head stud at this point.
Click to expand...

I always use a torque wrench to so over tightening is less of an issue...
 
Re: have VROOM again on engine rebuild, questions

500 is appropiate.
 
Re: have VROOM again on engine rebuild, questions

so does anyone have a list of suggestions of things to check @ 500 miles.
I already figure to check valve lash, spark plug condition, drain oil (replace oil filter), anything else? Is it a good idea to check head stud torque (or is this possibly going to cause issues, if done it would be with a torque wrench).
 
Re: have VROOM again on engine rebuild, questions

Timeing, brake adjustment, you know all the stuff, Might also check bolts in rear suspension for tight while you about it.
 
Re: have VROOM again on engine rebuild, questions

Actually 500 miles is when I recommend the first oil change, you can retorque the head and re-adjust the valve after a few heat cycles, you may find the head nuts furthest from center to be the ones that the most torque in retorque, you can do it now if you have a few heat cycles on the engine. In short, it's not miles deal, it a heat cycle deal.
 
Back
Top