• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Hardtop Spares

Share this page

Thanks for the offer , John and thanks to Lin for restating the link.
For some goofy reason, the link in your 6-6 post worked for me.
Saved the document, and now I have a great roadmap.
Just got the seal kit (HOD253) from AH Spares, so hope to get on with
this soon. Still waiting for seats and panel kits from moss.
Thanks again to both of you guys.
I am over in Sanger CA
Hank
 
I bought all the pieces for my 2 seater hardtop from Cape Engineering in UK. Prices were comparable and service was great. I would buy from them again.
Regards,
Bundyrum
 
I also followed Lin when I rebuild the Hard Top of my AH 100 6 Longbridge 1957
I have put on my album some Photos that can be useful in the rebuild
https://photos.app.goo.gl/pz9Ne26CS... 4 Healey UK -http://www.ahead4healeys.co.uk/
 
I used Lin's article and the article by Roger Moment in Chatter Mag June 1998. I ordered all parts from Cape Intl. Steve was extremely helpful with parts needed. I got a couple of BJ8 hardtop front hold downs and was able to modify them to fit my BT7
 
Has anyone else noticed the hard top latches from original tops are not quite the same as the reproductions. The flip handle on my originals were quite pointed at the ends but the repros are just rounded at the ends. Unfortunately I only had one original to go by so I now have the repros on the top.
 

Attachments

  • 2014-01-08 003.JPG
    2014-01-08 003.JPG
    2.1 MB · Views: 113
I had the base of a BT7 mounting bracket but the connector was missing. I kept looking on the net for someone who was selling a grouping of leftover parts and found two for the BJ8 top which is different than the BT7 but with a punch I was able to take them apart and modify the the handle and hook onto the mount.
 
Back
Top