Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Jim_Newman
Jedi Hopeful
Offline
I've seen some painted, some chromed. What is the proper way to refinish the handbrake lever?
As always, thanks.
Jim
As always, thanks.
Jim
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Handbrake lever
- Thread starter Jim_Newman
- Start date
Share this page
Randy Forbes
Yoda
Offline
Mine, BN6L-942, came chromed. I recently had it rechromed, but it won't be fitted until an upcoming xmsn swap.
Randy Forbes
Yoda
Offline
The after pictures...
Might as well show off the gear lever too!
The "short" one is my original (as seen in my previous post) and what I consider must be a "RHD" was found on Ebay as N.O.S. Iit appears to have never been used). I'll fit it to the car, but if it crosses too far right of center, I'll refit my original, even though the groove in the ball is wallowed out a little bit. If anyone needs a RHD lever, I can probably be talked out of it, so long as I recoup my costs.
Might as well show off the gear lever too!
The "short" one is my original (as seen in my previous post) and what I consider must be a "RHD" was found on Ebay as N.O.S. Iit appears to have never been used). I'll fit it to the car, but if it crosses too far right of center, I'll refit my original, even though the groove in the ball is wallowed out a little bit. If anyone needs a RHD lever, I can probably be talked out of it, so long as I recoup my costs.