Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
'65 3000, new rear shoes and as tight as I dare on all adjustments at rear. Handle all way up to get activation so as described in Haynes manual I went to the nut at the handle end of the cable which is up between drive shaft and frame rail. Any hints as to how to get a wrench on the nut (?size) or other ways of functionally shortening cable. As always thanks for the valuable advice. jay
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
handbrake adjust
- Thread starter why
- Start date
Share this page
Offline
Hi Jay,
It's much easier to adjust at the back end of the cable. See item #21 in this drawing. As you say, adjusting the front end is a real war.
https://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=28904
D
It's much easier to adjust at the back end of the cable. See item #21 in this drawing. As you say, adjusting the front end is a real war.
https://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=28904
D