-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
MGB-GT GT Vent window
- Thread starter Baz
- Start date
Share this page
OP
Baz
Yoda
Offline
The glass looks flat, but the rest has a curve to it, which would be explainable to follow the curve of the carbody, but the kink at the base (far right) is what bothers me.
The old one was broken in two, just below the right angle and the PO had taken the post out and tossed it, so I don't have that to check against.
The old one was broken in two, just below the right angle and the PO had taken the post out and tossed it, so I don't have that to check against.
Offline
The gradual curve is normal. The "kink" at the bottom is NOT normal. That base has a TON of adjustment down there... looks like the DPO may have just tightened it down with the window glass in the "up" position and figured that to be "good enuff." The kink appears to be right at the point where the glass stops.
