Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I am a new member with a '67 BJ8 and would appreciate any help regarding the sequence for mounting both the grille & eyebrow using the threaded rods (with welded nut in the middle). I am aware of the tabs at the opening and how to get the grille in through the wheel well, but my car was apart at time of purchase, so I am a bit lost. Thanks
-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Grille installation BJ8
- Thread starter carbuf60
- Start date
Share this page
Jeepster
Jedi Trainee
Offline
I installed my grill from the front of the car through the hole in the shroud. I had to bend the tabs to make it fit. Dont bend the tabs too much as it will leave an indent in the chrome. Make sure you first jack up the front of the car and remove wheels, and air deflectors etc.
It is a real pain of a job and will left me with bleeding hands and arms.
It is a real pain of a job and will left me with bleeding hands and arms.
Offline
Have a look at page 1
https://www.britishcarspecialists.com/pdf/austin-healey-rare-hard-to-find-oct2010.pdf
From what I remember ...
The tabs on the surround all have holes, put the surround and upper lip in first without fastners / bolts
Then put in the special bolts at the upper holes and outside holes at the underside
Then put in the grille (upper side first), and fasten all
https://www.britishcarspecialists.com/pdf/austin-healey-rare-hard-to-find-oct2010.pdf
From what I remember ...
The tabs on the surround all have holes, put the surround and upper lip in first without fastners / bolts
Then put in the special bolts at the upper holes and outside holes at the underside
Then put in the grille (upper side first), and fasten all