• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR4/4A greasing rear u-joint on tr4a

Share this page

bluemiata90

bluemiata90

Jedi Trainee
Offline
How do you get to the grease fitting on the rear outside u-joint on a TR4A. I've been trying to grease both outside u-joints, but can't figure out how to get my grease gun attached to the grease fitting. The trailing arm assembly is in the way and there are no access holes to get to the u-joint. Please don't tell me you have to remove the whole axle, but that seems to me to be the only way to do it. I hope someone else can make this easier for me. /ubbthreads/images/graemlins/confused.gif
 
I want to thank TRIUMPHSONLY for guiding me through the proper procedure of how to grease the outer u-joints on my TR4 IRS. It does require you to remove the rear half shaft, but once it was explained, the procedure was not that difficult and it did give me a little extra knowledge of the rear axle assemble. thanks
 
Back
Top