• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Gearbox Tunnel Vinyl Trim Secret

Share this page

Dave Richards

Dave Richards

Jedi Knight
Country flag
Offline
I need help!

I'm about done with the detailing, etc, the gearbox cover has it's new fancy heat shield on it and it's back in place.

I've purchased a fabric that closely resembles the material on the cover around the gearshift.

I need ideas about how to apply the material. It's not really flat, and the edge is rounded.

How did any of you apply this material???

Thanks, Dave
 

Attachments

  • 5395-gearshift.jpg
    5395-gearshift.jpg
    12.8 KB · Views: 113
Hi Dave,

My interior guy and I discussed this issue too.
He recommended using one piece of leather. That material could be stretched, therefore there would be no meeting of the two ends in cutting another type of material to make it fit.

He used contact cement to hold it in place.

photo attached.
Roger
 
Nice! No wrinkles, that's the part that's frustrating me, but I've been thinking about this for awhile, and I think one piece is the way to go. Thanks!
 
Back
Top