• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Gear lever thread size

Share this page

R

RobWarren

Jedi Hopeful
Offline
Folks,

I'm looking to get a new gear knob for the BJ8, in stainless steel - a plain sphere. I suspect that if I get a modern-made one I'll neeed it to be tapped to fit the thread on the lever.

Anybody know what size the thread is?

Bob
 
I put my own knob on using a modern threaded sleeve insert. I think it was 3/8" coarse thread?
 
measure the outside diameter of the male thread then lay a ruler along the theaded portion count the number of Threads Per. Inch resulting in for example: 3/8 ins. O.D. 12 TPI this thread size will be recognised as a standard by any machine shop. Job Dun.
 
Back
Top