• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

General Tech Gaskets—Head/Oil Pump

Share this page

KVH

KVH

Obi Wan
Silver
Country flag
Online
I have a nice composite head gasket I ordered from Maas. I plan to install it without any form of gasket sealer. Is that Okay?

Also, I installed my oil pump last night and applied a thin coat of gasket sealer on each side of that gasket. I realize it is in the sump, but since the kit included a gasket I felt gasket sealer couldn’t hurt. Any thoughts there?
 
For the oil pump, I decided to use a new oil pump gasket with no sealer. I see no sealer recommended and I suppose I could cause issues with drive rod clearance or even gumming up the pump.
 
In general...gaskets should not need any sealant. That said, they do depend on good contact surfaces. As our engines age and accumulate rebuilds, the surfaces are not always that good. If you have any doubt about the sealing surface condition, then a gasket sealant is good insurance to bridge any imperfections.
 
I've never understood the need for a gasket where the oil pump bolts to the engine block. There can't possibly be enough leakage at that joint to affect oil pressure, and any leakage just flows back into the sump. Still, because it's there, I used one. No other reason.
 
I used a copper spray sealer on the head gasket. I used a Payen copper gasket, and I’m not sure if a composite gasket needs an additional sealer.
 
Back
Top