The large square aluminum spacer that fits behind the brake servo up against the bulkhead, should there be some kind of sealant between the spacer and the painted bulkhead? In the past, I have used a bead of silicon here but now that it is off and the hydraulics being rebuilt, I wonder?
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Gasket behind servo aluminum spacer?
- Thread starter TR6BILL
- Start date
Share this page
LastDeadLast
Jedi Knight
Offline
I don't have anything there...but I don't suppose it would hurt either way.
-s
-s
TR6oldtimer
Darth Vader
Offline
Mine had, and will again have, DumDum (or 3M). The same stuff used on the floor pan bolts and the inner rear fender bolts.
