Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
To initially adjust the clutch slave rod ......should the cross shaft be pushed "rearwards" so the release bearing is just touching the "3 fingers" of the pressure plate.......then the slave pushrod is lengthened/shortened so that the pushrod fork lines up with the middle cross shaft lever hole? Hope this makes sense.
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
TR2/3/3A Further to Clutch Slave Adjustment......
- Thread starter karls59tr
- Start date
Share this page
TR3driver
Great Pumpkin - R.I.P
Offline
I find the spring to be much easier to install with the adjustment backed off, so I usually put it on first and then do the adjustment. One method is to have the linkage connected, unscrew the adjustment until it is solid (meaning the pushrod is holding the bearing against the fingers), turn the nut until you have the specified gap between it and the clevis; then turn the pushrod until the nut touches the clevis. Tighten the nut and you're done. Written up in the TR4 workshop manual, I think.
I just pull the lever against the spring as hard as I can, and check that there is some free play in the pushrod. I prefer mine tighter than the factory adjustment anyway, and don't mind checking it more often. The adjustment closes up as the clutch wears, and it's important that there always be some clearance.
I just pull the lever against the spring as hard as I can, and check that there is some free play in the pushrod. I prefer mine tighter than the factory adjustment anyway, and don't mind checking it more often. The adjustment closes up as the clutch wears, and it's important that there always be some clearance.
