• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR2/3/3A Furflex Door Seal - Where does it go?

Share this page

Lbp

Lbp

Senior Member
Offline
On a TR3A, does the Furflex Door Seal go all around the door (except across the top, of course)? Does it mount between the door and the door panel, held on by the panel mounting screws?

Thanks,

Bill
 
No, a long piece runs along the A post from the scuttle all the way to the bottom and is mounted behind the foot-well trim panel. A smaller piece runs up along the B post and is mounted behind the dog-leg trim panel. All the rest are small rubber seals attached by clips.

Joe
 
Yes there's no Furflex on the doors at all. Near the top of the door is a length of contrasting piping between the door card and the capping. Along the underside there's a rubber seal as Joe described. Often the repro rubber seals are too thick and cause door closing problems, in fact I gave up bothering with them. No dust or water gets in as a result.

Viv
 
Thanks for the help. I sure wish I'd had a resource like this site when I was working on my Bug-Eye Sprite 36 years ago!
 
Back
Top