• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Fuel line size and fittings

Share this page

R

rfitts

Freshman Member
Offline
installed new aftermarket fuel tank in 1961 BT7. The fuel line going through the backwall of the trunk to the tank is too short. I will need to bend up a new fuel line from the pump to the tank. How can I go about specing out the right fuel line and fittings?
 
Google "Mr Fine Spanner"
 
yard-Healey2010011.jpg

I have a rubber hose that connects the fuel tank fitting to the steel fuel line.
 
There are a few elements of my car that aren't original, the fuel line being one of them...

I used 3/8" stainless steel tubing and associated Parker (or SwageLok) ss compression fittings.

I'm pretty sure that the original run was 5/16" tube, in mild steel with soldered brass fittings.

IMG_6649.jpg
 
Hi, Fuel tank outlet, if original, should be 1/4" BSPPT (British Standard Parallel Pipe Thread). It needs a 60 degree cone seating with a nut holding it in place. There are adapters available to use an AN fitting. Pegasus Racing has a pretty good overview (www.pegasusautoracing.com) . Good luck, Bob
 
Back
Top