• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Fuel Gauge Needle Shakes

Share this page

af3683

af3683

Jedi Trainee
Country flag
Offline
The fuel gauge needle on my TR3B is constant when the ignition is in the on position, but shakes when the car is started. The wire on the gas tank send unit is secure. If tried to check the conections on the back of the fuel gauge, but am having trouble getting my hand up there. Is some shaking of the needle normal?

Thanks,
Art
 
Art, that really does sound like a loose connection. Is the sender tight in the tank?
 
I know that the sending unit connections were tight last October because I checked them before I installed a millboard panel. I'd be surprised if they loosened up because I have not driven the car much.
 
Might be the alcohol in the fuel
Bourbon makes me shake
 
Most likely IMO would be a poor ground at the gauge. Although I'm still not certain if the factory installed a ground wire or not; the vast majority of cars seem to be relying on the clamp to ground the gauge to the panel, which is far from secure. TR4-onwards doesn't need a ground for the gauge, but the 'balanced' gauge used on TR2-3B does.
 
I checked the clamp on the fuel gauge and it appears to be fine. I'm now back to examining the ground wire from the gas tank sending unit. My ground wire goes from the sending unit to the <span style="text-decoration: underline">left</span> strap that secures the gas tank. Specifically, the bolt goes thru the strap which goes thru the ground connector which then screws into the trunk. Does anyone know if this is the correct sequence or should the bolt go thru the ground connector and then thru the strap and then into the trunk? Also, any chance that the ground should go to the <span style="text-decoration: underline">right</span> strap or does it matter? Thanks again.

Art
 
Art, just try running another ground as a jumper at both ends to see if the problem stops.
 
Back
Top