• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Front suspension problem

Share this page

M

Mmeck

Freshman Member
Offline
Right side suspension lower inside fulcrum pin steel sleeve, ( number 57, page 236 Haynes Manual), just will not move. Tried about everything I could think of to get it off to replace, but no luck. I'm rebuilding the suspension with the TRF kit and this has been the only setback. Any ideas???
 
Use a Dremel and an abrasive cutoff wheel to cut almost all the way through the sleeve, as far as you can without cutting into the frame bracket. Then use a BFH & cold chisel to break the sleeve the rest of the way.
 
Excellent. I'm going to do that this afternoon. I really appreciate the great help on this forum. Thanks again Randall.

Mike
 
Back
Top