• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR2/3/3A Front suspension inner Lower wishbone bush area?

Share this page

K

karls59tr

Obi Wan
Bronze
Country flag
Offline
Are the nylon"washers"(Moss diagram part # 115) supposed to be somewhat loose. I noticed that they could be moved from side to side a bit yet the fulcrum nut that holds the bracket seems to be torqued the correct amount.
 
You have the nylon washers on both sides, and part 123 the right way around? I dont recall this being loose when I did mine.
 
They are a sliding fit. Not a rattle fit, but no press needed. Cheap so replace. Grease both sides when installing.
 
You did a trial installation without the arms? I never tried the bushings without the arms, so I don't know if they are loose inside the arm or not.
 
Back
Top