-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR2/3/3A Front hub wheel bearing nut?
- Thread starter karls59tr
- Start date
Share this page
TR3driver
Great Pumpkin - R.I.P
Offline
No, that's the wrong procedure. The bearing clearance was revised several times, along with not torquing to 10 ftlb.
If you are reusing the old felt:
With new felt, you need to do a test installation without the felt and mark the position; so you don't get fooled by the thickness of the felt:
If you are reusing the old felt:
With new felt, you need to do a test installation without the felt and mark the position; so you don't get fooled by the thickness of the felt: