• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Flanging tool for lap welds

Share this page

A

Angusdog

Freshman Member
Offline
I want to form a flange for doing stronger (?) lap welds rather than butt welding new steel into my mini. This will give me the option of doing seam welds, stitich welds, plug welds or a combination thereof, depending on the structual integrity required.

I bought a 2nd hand air powered one, which didn't work and can't find anyone local to fix it.

Anyone used and can recommend one? Practical Classics mag did a review of hand crank versions, but hands-on advice would be appreciated.

Thanks,

Simon.
 
Simon, here in the States, Eastwood sells them that are based on Vise Grip pliers. There are two stepped blocks welded to a pair of 10" Vise Grip pliers, that when squeezed form a flange about 1/2" from the edge of the panel. They come in widths from 1/2" to 1 1/2". That's all I've used for years, and have had very good luck with them. It can get a little tedious when doing long runs, but it makes a great joint when finished.
I found the hand cranked roller types hard to control. It seemed the panel always wanted to wander away from the stop, so the flange looked like a snake.
Perhaps an auto body shop, or local panel beater can steer you towards something available "Down Under".
Jeff

[ 01-27-2004: Message edited by: Bugeye58 ]</p>
 
you wouldnt happen to have a photo of those would ya?

mark
 
thats it!... wow.
 
Great tool . I 've had one it seems forever.Great for making patch panels.A couple of rivets to hold in place and then simple to weld it in.
 
Back
Top