• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Fender > Door Seal

Share this page

W

Wausau 911

Member
Offline
Continuing to sort out my bJ7, and I noticed I am missing weather seals where the doors meet the upper fenders. Looks like the seal should be about 6-8 inches. Is the material the same as the OEM seal that runs on bottom and up to the where the rear door opens? My fender has 2 holes that would appear to be for rivets. Thx for all replies, and if someone could take a picture of theirs that would be great.
 
Is the material the same as the OEM seal that runs on bottom and up to the where the rear door opens?

Yes and they are called Draugth excluders in the parts catalogs. As I recall they are one long piece of Fur Flex.
 
I think what you are referring to are the 'scuttle seals'. If you google Austin Healey Scuttle Seals, you will get some good info: pics, installation tips, sources to get 'good ones'. And, they are riveted on.
I include a pic of them on my car, but I don't have access to it right now.
Anyway - hope this helps.
 
I looked all over trying to figure out what the BJ7 set up was when I did mine. As near as I can make out from Anderson-Moment, Clausanger and elsewhere on the net, these pictures are pretty accurate. Hope they help. IMG_0343.jpgIMG_0344.jpgIMG_0345.jpg
 
Back
Top