• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Falcon Headers

Share this page

A

arbs_53

Senior Member
Offline
I just installed a set of Falcon S.S. 3-2-1 headers onto my TR250 today and there is one nut that goes underneath that holds the back end of the front half of these headers and the intake manifold to the head that is a royal pain to get to...For one thing, there is an extremely small gap among the pipes in order to see what I'm doing; the head stud is so close to the pipe that I can't fit a socket on it, there is barely enough room to get an open end wrench on it. I've gotten it to the point were it seems tight but I can't be 100% sure as the flats of the nut are in such a position that I can't get the wrench on them anymore. I'm sure there must be someone out there who has installed these on a TR250, or an earlier TR6 that uses the same style intake, who has encountered this same problem. What I need to know: what magic tool did you use to tighten that sucker? /ubbthreads/images/graemlins/confused.gif
 
Dave, I recently installed the Falcon headers on my TR6 (same basic head as your 250) and resorted to grinding some of the corners off that offending nut and using a good quality star washer to allow the nut to suck up more onto the stud. I used a "crow's foot" spanner and was able to torque down the nut satisfactorily.

Bill
 
Dave, I put headers on my car, and they are a popular upgrade for cars we fix and restore at the shop, and grinding MUST be done to get them on. Like Bill said, you can use a crow's foot wrench to tighten it up, or just grind a little more off to get a socket on it. Either one will work.
 
Back
Top