• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Exhaust/intake gasket

Share this page

VelodromeRacer

VelodromeRacer

Jedi Trainee
Offline
I am about to install my intake/new exhaust header and while I have the gasket, I wonder about the gasket.

Do you use any sealant on both sides of the gasket? I was wondering if I should wipe a thin amount of RTV red for high heat on both sides?

Thoughts?
 
No sealer on that. Just make sure the surfaces are clean.
 
Ok, Getting the idea here...
I am re-installing my race engine after changing to the Taylor Box I bought from Hap. I am in the process of getting a custom exhaust next and wanted to double check before I install the intake/exhause.

Thanks.
 
Also if you are ported and using a header, consider a competition gasket.
 
I had a leak due to a weber header on the car and couldn't get it to seal on the intakes. Finally I resorted to a little fuel resistant/ high heat sealer and it worked well. I agree with the others, it is best to not use it and it really shouldn't be necessary, but if you run into any problems with aftermarket mods it will help.
 
Back
Top