• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Engine test stand

Share this page

T

tonyk

Member
Offline
Hi. Engine rebuild nearing completion. I was wondering if it's feasible to test the engine out, run in the cam, check for leaks and sort out explosive or non starting problems etc on a simple rig. Engine is currently mounted on a couple of sturdy wood "saw horses" - made many years ago by a professional joiner (mainly constructed from 2"x4").

I've seen such testing rigs mentioned from time to time but I can't find anything useful in the archives. I know you have to fit up water feed - radiator or nrunning water from a tap, gauges starter etc.

Anyone any advice, plans that would help. Is it feasible to do this in the garage?
 
I think it is a great idea. If you give it a google, you will see many well thought out (and some not so well thought out) ways people have done this.
 
An old chassis works pretty well for a test stand. Stick a dyno in where the diff goes and make some noise

 
I've seen V8s running on the shop floor before, though gentle blipping of the throttle is recommended!

I don't think running water straight from the tap is such a good idea, as you'll want it to reach and maintain normal operating temperature; a closed circuit (radiator, thermostat and electric fan) would be be preferred, if the engine is going to be run anything longer than a couple of minutes.

With just a little modification, this would've been adequate for starting and running at low (<2000) RPM:
(this is Healey Blue's handiwork, btw; xlnt for shipping some 1100 miles)

IMG_1384.jpg


IMG_1386.jpg


IMG_1399.jpg
 
I made a simple frame and put some casters on it so I can roll it out of the garage to run, while the body is being finished.

Digger

Austin Healey motor stand2.jpg
 
Good idea but I think most people just put back in the car and run it. I did make a temporary "Mule" out of plywood and casters which really came in handy fitting the tranny back in. Most likely I could've ran the engine on the stand but I didn't want to put the manifolds and carbs plus the starter/generator back on then have to take them back off to install the motor back in the car.

resto 3 19 20050002.jpg resto 3 19 20050001.jpg
 
Hi

Thanks for all the replies. Pictures are worth a thousand words - very helpful and I think I've got the idea now.
Unfortunately, when I came to hook up my brand new tubular headers (cast iron original had cracks when I checked them out) neither would fit as the bolt holes were offset on both manifold flanges.

Poor quality control by the supplier and not checked by the merchant, I am getting a replacement set.
 
tonyk said:
Hi

Thanks for all the replies. Pictures are worth a thousand words - very helpful and I think I've got the idea now.
Unfortunately, when I came to hook up my brand new tubular headers (cast iron original had cracks when I checked them out) neither would fit as the bolt holes were offset on both manifold flanges.

Poor quality control by the supplier and not checked by the merchant, I am getting a replacement set.
Click to expand...
I should have photos of our local clubs test stand within a month to post. It has radiator, gauges, etc, dummy trans.
 
Back
Top