• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Engine reinstall preparation questions

Share this page

W

Whitephrog

Luke Skywalker
Offline
Getting close to re-installing the engine in the Whitephrog. I seem to remember some advice about one motor mount on the engine and the other on the frame. Is that correct? Do it matter which side is which? What should I install on the engine before putting it back in the car? What should I definitely not install before?
 
Bolt the motor mount to the car on the steering wheel side.
Keep the passenger side handy but not bolted in until the engine is close to it's final resting spot then bolt the rubber to the engine and lower it in and bolt the metal mount to the frame.
It's tough to get the metal part around the steering column. And this goes for RH drive cars too.
 
Another tip, is do not reverse the mounts side to side and up side down. The bolt for the motor mount is on the bottom, and there is a notch on the front side for the steering shaft for both right and left hand drive. The photo shows a mount for the driver's side (left-american).
 

Attachments

  • 19290.jpg
    19290.jpg
    79.9 KB · Views: 217
regularman said:
Go outside and do a whole lot of cussing and get that all out of your system before you start :wink:
Click to expand...

That doesn't work. It's like toothpaste. There's always some left in there.
 
Back
Top