• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

drivers side 4 inch vent hose

Share this page

maxwedge5281

maxwedge5281

Jedi Warrior
Country flag
Offline
there is a large metal hoop...not clamp...that helps to support the drivers side vent hose. can anyone tell me where this supporting hoop is located on the hose and is there a predilled hole for it to mount on the inner fender? thanks for any help!
 
Yes it is located where you find that pre-drilled hole on the inner fender-- look for it.
 
keoke, that is part of the problem, i have several holes . i think that i have found the correct one. i was too far forward on the inner fender. i found a hole that seemed to locate the tubing bracket correctly to the rear side of the shroud support. thank you.
 
maxwedge5281 said:
keoke, that is part of the problem, i have several holes . i think that i have found the correct one. i was too far forward on the inner fender. i found a hole that seemed to locate the tubing bracket correctly to the rear side of the shroud support. thank you.
Click to expand...

Yea that sounds about right you did a better job of describing it's location than i would have
 
Keoke said:
Yea that sounds about right you did a better job of describing it's location than i would have
Click to expand...

Does this help
 
thank you. unless the bracket is for a different model, i have it on the wrong side of the shroud support. thank you.
 
Back
Top