• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

drivers side 4 inch vent hose

Share this page

maxwedge5281

maxwedge5281

Jedi Warrior
Country flag
Offline
there is a large metal hoop...not clamp...that helps to support the drivers side vent hose. can anyone tell me where this supporting hoop is located on the hose and is there a predilled hole for it to mount on the inner fender? thanks for any help!
 
Yes it is located where you find that pre-drilled hole on the inner fender-- look for it.
 
keoke, that is part of the problem, i have several holes . i think that i have found the correct one. i was too far forward on the inner fender. i found a hole that seemed to locate the tubing bracket correctly to the rear side of the shroud support. thank you.
 
maxwedge5281 said:
keoke, that is part of the problem, i have several holes . i think that i have found the correct one. i was too far forward on the inner fender. i found a hole that seemed to locate the tubing bracket correctly to the rear side of the shroud support. thank you.
Click to expand...

Yea that sounds about right you did a better job of describing it's location than i would have
 
Keoke said:
Yea that sounds about right you did a better job of describing it's location than i would have
Click to expand...

Does this help
 
thank you. unless the bracket is for a different model, i have it on the wrong side of the shroud support. thank you.
 
Back
Top