-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
MGB Drive Shaft U-Joint, 1978 MGB
- Thread starter Midgey
- Start date
Share this page
tony barnhill
Great Pumpkin - R.I.P
Offline
no big deal - usually, for me, getting the driveshaft out from under the car is the bigee!
Offline
Tony I replaced the ujoints in a drive shaft on a 79 and one end was froze so hard that I had to put it in my press to break them loose. Before doing so, I milled a small piece of angle iron to fit between the yoke to keep from distorting the shape of it in the press. It worked very well. My 72 ujoints came right out with no problem. PJ /ubbthreads/images/graemlins/hammer.gif
tony barnhill
Great Pumpkin - R.I.P
Offline
8 bolts, Jim....4 on either end....then I just press them out