• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR2/3/3A DOT 5 Brake Fluid

Share this page

R

Redoakboo

Jedi Warrior
Offline
Is there a difference between DOT 5 and DOT 5.1? Most of these are synthetic, will these work O.K. in a 54 TR-2 brake system?

Dick
 
Yes, pretty big difference between 5 and 5.1. Former is silicone, later is glycol based. It's an odd numbering system.

Ed
 
It is my understanding that Dot 5 will NOT take paint off, whereas DOT 5.1 will take paint off. I like DOT 5 and use it in both my TR250 and my TR3.
Bob
 
Can't mix DOT 5 & 5.1. Advantage of DOT 5 is it is silicone and will not absorb moisture and like Bob said it won't take the paint of if you spill it. 5.1 has a higher boiling point and will absorb moisture. Not a good thing for our cars.
I have it in my TR3As system. Love it! Also in my TR250 however I kept have an issue with the clutch slave cylinder. The DOT5 would leak out if I didn't drive it for a while. From what I understand is that the molecules in silicone are smaller and can get past the rubber seals. So recently I rebuilt my slave cylinder and will be running DOT4 in it. I'm in Ohio so it will be some time yet before we get LBC weather around here.
 
I have used DOT5 in my GT6 for years, and have never had a leak of any kind so not sure if I am just lucky or what. I don't see a reason that it would leak though. Definitively it does not damage the paint as I spilled a bunch by accident.
Hope that helps
 
Back
Top