• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Doortop fingergrip installation

Share this page

tr6web

tr6web

Jedi Trainee
Offline
Anybody have any suggestions on installing new doortop fingergrip crashpads? Should I put the clips on first and then spray adhesive to the pad and then put in on the door tyring to slide the edges under the clips? Or put the clips on last and everything else first? Any suggestions would be helpful. Thanks.
 
Mike, put the doortop fingergrips on first. I not sure about a spray glue in this case, a small bottle with a brush would keep it off the paint. Then put the clips on and using a bent peice of flat metal making a small hook at the bottom, may take a couple of times to get the bend right, pull up on the clips and push the weather strip into the clip. Works just as well on the out side rubber as well, just make sure you are in the slot designed for the clip on the outer rubber. I has seen a special tool for this in Moss and a real nice one on Ebay, if I had ten to do Yea but one, go with the bend. Wayne
 
Back
Top