• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR2/3/3A Door seal

Share this page

R

RonR

Jedi Trainee
Country flag
Offline
Hi Folks.

How does the fuzzy seal at the strike side of the door terminate at the top?

I can't find a picture of this in any of the Triumph books that I have.
Thanks.
Ron
 
Same as the A pillar that curves up by the dash. You have to trim the inside hollow rubber piece (about 1/2") and then stuff the outer fuzzy part into the center of the rubber. So, allow the extra length for this. I didn't allow for this and wound up gluing some fuzz on top, which actually turned out looking quite good.
 
Back
Top