Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I'm installing new door top rails and upholstered panels on my 66 BJ8. If I were to place the door pulls in the existing holes on the metal part of the door, they would interfere with the bottom of the door rails. Additionally, they would be right at the junction of the rail and the top of the panel. What would make sense is to drop the pulls down just a bit, so that a clean hole can be made about one inch down from the top of the panel. But this location is clearly not where the pulls were installed at the factory. Anyone have ideas about correct placement of these pulls vis-a-vis the top of the panels/bottom of door rails? Thanks.
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Door Pulls
- Thread starter Cutlass
- Start date