• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Door lock help

Share this page

abarth69

abarth69

Jedi Warrior
Offline
When I put this altogether the inside door opener wants another 1/4 to 1/2 of inch to open the door.

Help
 

Attachments

  • 12202.jpg
    12202.jpg
    73.3 KB · Views: 202
I know nothing of these but I bet the handle can be moved on the pin that goes in to the in side. Your handle is in the center and should be to one side some more to get the full throw.
 
The handle fits on a square shaft. It should be more towards the front of the car. I've never looked closely at these so I can't say what the problem may be.
 
Ahhh, make it so. Turn the shaft a bit and reinstall the handle.
 
Ahh, on something. Sounds good, a drop of JW Black should fit the bill.
 
Make sure the handle pin is in the hole on the latch. If you missed it that would take extra movement to open the door.
 
I think your picture is a little wrong Dan

The round peg doesn't fit into the square hole.

Mark
 
You are correct sir. I shouldn't talk about these new fangled cars until I'm sure what I'm talking about.
2647597799_81424eea7c.jpg

It should go in the rounded slot.
 
"That's okay Dan this is what this place is all about.

Now if I could figure out what my problen is.

Mark
 
And that's the hard part, identifying the problem. All down hill from there.
 
Back
Top