• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Distributor mount removal.

  • Thread starter Deleted member 19315
  • Start date

Share this page

D

Deleted member 19315

Guest
Guest
Offline
Hi all. A question if I may. My car has a slight oil leak from the base of the distributor mounting pedestal where it bolts to the block. Is there anything to be wary of when removing it like parts that can fall off into the motor. I'm just wanting to check it's all flat and fit a new gasket. I noticed someone has been there before and the current gasket looks homemade, which is fine but this one's not done well. I'll also fit a DW clamp for my Mallory dizzy while I'm in there.

Andy
 
You'll be fine with distributor removal; there are only two and really nothing to fall into the hole. Just be sure to correctly index engine and distributor to TDC. A homemade gasket works fine but check distributor o-ring condition. GONZO.
 
Back
Top