-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
-
When posting a classified ad, you MUST select a prefix from the drop-down next to the subject line. If you don't you will get an error and your ad will not be posted!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Dimensions requested for floor drain deflector
- Thread starter BlueMax
- Start date
Share this page
Jim_Gruber
Yoda
Offline
Nice work. So was that a cut and bend and weld on the lip thing or a hammer and form job to make. Can you share the process?
OP
BlueMax
Jedi Warrior
Offline
What I did was anneal the steel with a rich acetylene torch to take the temper out. Then hammer the steel out on a die that I made from wood. After all of the shaping and finishing was done then heat it up again then quench, ready to weld in. Dimensions are 2.5” x 2”x 1” length-width-and width of center.