• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Dimensions requested for floor drain deflector

Share this page

BlueMax

BlueMax

Jedi Warrior
Offline
Borrowed the photo from Gerald, hoping someone can supply the dimensions of the floor drain deflector on the Bugeye Sprite? Thanks
 
Nice work. So was that a cut and bend and weld on the lip thing or a hammer and form job to make. Can you share the process?
 
What I did was anneal the steel with a rich acetylene torch to take the temper out. Then hammer the steel out on a die that I made from wood. After all of the shaping and finishing was done then heat it up again then quench, ready to weld in. Dimensions are 2.5” x 2”x 1” length-width-and width of center.
 
Wow, thats amazing! Very nice work. What kind of wood? I assume maple or cherry and piece of square stock to use as a punch.

Kurt.
 
Back
Top