• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Did they use JB Weld?

Share this page

Dadandson

Dadandson

Jedi Trainee
Offline
The former owner took a short cut to install a new radiator and bent the shroud up to get it out on my 74 1275 Midget. Then they bent it back. It has finally broke the bracket off the top of a perfectly good radiator. It looks like the radiator mfg used JB weld to attach the brackets. Any ideas to re-attach? Good thing I noticed this because the rad could lean into the fan and then I would have new problems.
 
Sodder.
 
I am going to drop it off at a local rad shop tomorrow to have the bracket soldered back on. I might as well have them check it out while it is there.
 
There ya go. Good insurance.
 
Back
Top