• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Did they use JB Weld?

Share this page

Dadandson

Dadandson

Jedi Trainee
Offline
The former owner took a short cut to install a new radiator and bent the shroud up to get it out on my 74 1275 Midget. Then they bent it back. It has finally broke the bracket off the top of a perfectly good radiator. It looks like the radiator mfg used JB weld to attach the brackets. Any ideas to re-attach? Good thing I noticed this because the rad could lean into the fan and then I would have new problems.
 
Sodder.
 
I am going to drop it off at a local rad shop tomorrow to have the bracket soldered back on. I might as well have them check it out while it is there.
 
There ya go. Good insurance.
 
Back
Top