Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Colleagues,
I am preparing my BE for new paint to be accomplished soon I hope. Yesterday involved removing the dash, it came off reasonably well however, I could not remove a couple of knobs wiper and another that had a small 'rivet' in the stem seemingly as a set screw?
It is not a screw with slot for screw driver but seems to be press fit piece of metal with flat surface. I tried to gently unscrew the knob thinking it might be threaded on the cable to no avail. I removed the dash with these knobs and their respective wires in situ, pulling them through the firewall.
Any suggestions would be welcomed.
BTW, very cool to read the yellow crayon build notes on inside of dash, they complement the blue crayon notes discovered underneath the Hardarth original mat in the boot.
I am preparing my BE for new paint to be accomplished soon I hope. Yesterday involved removing the dash, it came off reasonably well however, I could not remove a couple of knobs wiper and another that had a small 'rivet' in the stem seemingly as a set screw?
It is not a screw with slot for screw driver but seems to be press fit piece of metal with flat surface. I tried to gently unscrew the knob thinking it might be threaded on the cable to no avail. I removed the dash with these knobs and their respective wires in situ, pulling them through the firewall.
Any suggestions would be welcomed.
BTW, very cool to read the yellow crayon build notes on inside of dash, they complement the blue crayon notes discovered underneath the Hardarth original mat in the boot.
