StupidHippie
Freshman Member
Offline
Hi All,
Saw the drink holder thread from Jan 07 in the archive and thought (fully aware of the potential wrath from some) I'd offer my homemade version for a critique...
It's made with 3/16" steel wire bent around a suitably sized pipe and MIG welded. A 1"x2"x 1/8" tab tucks under the console providing more than enough support for two large coffees. The hole seen in the tab is for an anchoring screw, but once the console is tightened it is not needed. My main considerations in building this were providing a safe, relatively spill proof holder without causing any permanent harm to the car.
We've used the holder on several outings and it has passed the 'MRS' test for convenience and reliability. She likes the way the coffee tucks in under her leg, but is still an easy reach.
More pix here
Paint is just semi gloss 'Tremclad' to match the interior. I imagine most interior colors could be matched.
Hope this brings some more ideas out into the open,
Rob
74.5 TR6 Mimosa/black
Saw the drink holder thread from Jan 07 in the archive and thought (fully aware of the potential wrath from some) I'd offer my homemade version for a critique...

It's made with 3/16" steel wire bent around a suitably sized pipe and MIG welded. A 1"x2"x 1/8" tab tucks under the console providing more than enough support for two large coffees. The hole seen in the tab is for an anchoring screw, but once the console is tightened it is not needed. My main considerations in building this were providing a safe, relatively spill proof holder without causing any permanent harm to the car.
We've used the holder on several outings and it has passed the 'MRS' test for convenience and reliability. She likes the way the coffee tucks in under her leg, but is still an easy reach.
More pix here
Paint is just semi gloss 'Tremclad' to match the interior. I imagine most interior colors could be matched.
Hope this brings some more ideas out into the open,
Rob
74.5 TR6 Mimosa/black