• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Crankshaft timing gear

Share this page

A

AdamPP

Freshman Member
Offline
The Previous owner tightened the pully nut on the crack shaft extremely tight. I was able to get the nut off, but the timing gear that attaches to the crankshaft will not come off. I believe I have the duplex set up because there is two chains and no tensioner. (1275) Does some other bolt keep the crankshaft timing gear one? i've tried screw drivers behind the thing, but it won't budge. I think the moonkey may be in the way, but I can't get that thing to slide either. I have an En16T crank if that helps.
Regards,
Adam
 
Yes that worked, but it order to use the gear puller I had to cut off the chain to make enough clearance and wrap the chain around the second set of teeth. Gear puller then pulled on chain which pulled the gear off. Thanks
Regards,
Adam
 
Back
Top