• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR6 Correct LED flasher relay

Share this page

Gliderman8

Gliderman8

Great Pumpkin
Gold
Country flag
Online
Currently I have LED bulbs (1157) in the Front Left/Right turn signals and regular incandescent (1156) in the Rear Left/Right turn signals.
All turn signals work as they should. Tonight I replaced the rear turn signal bulbs with LED bulbs and turn signals do no flash.
Can someone recommend an electronic LED flasher unit that will work in my car? Make? Model number?
 
Not sure on the TR^ but the flasher circuit on the TR2-3 cars need a third contact for the dash indicator.

What is shown on Amazon and Moss are two contact units.

I have not tried one yet but my research has led me to the flasher EF33RL also available at Amazon and local car part stores.

Good luck with your turn signals may they blink brightly.

Roger
 
Elliot, I converted my TR4a turn signals (and brake lights) to LED bulbs, and used the Moss CEC electronic flasher (3 prong). I then had a problem where the stock turn signal indicator on the dash would continue to flash (for 10-15 seconds) after the signal was turned off. I have read on the various forums of others having this same issue.

As a test, (though Moss advises against doing this), I replaced the dash indicator bulb with an LED after market bulb that I found at my FLAPS. This fixed the problem to the extent that the indicator then only flashed one or two extra times after turning off the indicator.

I lived with it like that for awhile until I read of someone solving this problem using a “Flosser” electronic flasher. I found that British Parts Northwest sold them. I swapped one in and the problem went away. The only obvious difference between the CEC and Flosser units is that the CEC has a separate ground wire, while the Flosser does not.

Good luck,

Jim
 
Thanks guys. I just ordered the EF32RL. Hopefully that will work including the indicator light which by the way already has an LED bulb and is working fine.
 
Last edited:
The EF32RL arrived today. I just installed it and problem solved!
Jim- I can tell you that after the turn signal ends the indicator on my dash flashes maybe two times; I do not find it at all annoying since it only lasts 1-2 seconds. By the way, the indicator bulb is also LED.
Thanks for all the help guys!
 
Back
Top