-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
correct BJ8 jack
- Thread starter Hoghead
- Start date
Share this page
Bob_Spidell
Yoda
Offline
It's a metal rod about 18" long and (I think) about 7/16" diameter, with slightly chamfered ends. This Forum's moderator Reid Trummel had some repros made a few years ago. I think you could make a decent one with some rod and a grinder.
The jack number sounds right, but I'm not positive. There are two versions of the jack, the later/best one has some additional webbing to reinforce the hole where the handle goes. They come up on eBay once in a while, but usually go for $300-400.
The jack number sounds right, but I'm not positive. There are two versions of the jack, the later/best one has some additional webbing to reinforce the hole where the handle goes. They come up on eBay once in a while, but usually go for $300-400.