• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

MGB Clutch Slave push rod...past its prime

Share this page

Joe Reed

Joe Reed

Jedi Warrior
Country flag
Offline
Think it's time to replace this? :D I knew the clutch release point was closer to the floor that I liked, but I didn't expect the push rod to look quite this bad! Also, check out what the PO used instead of a proper clevis pin.

IMG_5310.JPG
 
A fairly common issue. We've replaced dozens of those pins for the same problem. I keep one clevis pin on the Wall of Shame, so worn it looks like a miniature crankshaft. The rod it was holding in place looked like yours and the same with the pedal. Had to weld and re-drill the hole in that.
 
I knew this one wasn't going to be pretty so I already had a new push rod and clevis pin on hand...
 
Back
Top