Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Marvin Gruber
Yoda
Offline
Hate to sound like a dummy but I have never had to do it but you can replace the clutch in a BJ8 just like you would in a Triumph? Just pull trans out from inside the car?
Marv
Marv
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Clutch replacement on BJ8
- Thread starter Marvin Gruber
- Start date
Share this page
bob hughes
Luke Skywalker
Offline
You do have the added complication of that center console bit over the tunnel.
I took my passenger seat out to do mine on my BJ7 and passed the trans out through the passenger door and onto a trolley.
Watch out for that accelerator spindle support into the bulk head when you lift the rear of the engine up - don't ask me how I discovered that!
Bob
I took my passenger seat out to do mine on my BJ7 and passed the trans out through the passenger door and onto a trolley.
Watch out for that accelerator spindle support into the bulk head when you lift the rear of the engine up - don't ask me how I discovered that!
Bob
OP
Marvin Gruber
Yoda
Offline
Job done, well almost. Have to put seats and console back in. Wasn't that bad. More room to work than the Triumphs. Trans is lot heavier, I just easied it out to the left of cockpit , replaced clutch and slide it back in place. Took about 4 hours to remove and replace. About an hour, maybe two to finish with seats. Going to do some deep cleaning while apart. Glad its this far done.
Marv
Marv
Bob_Spidell
Yoda
Offline
Did you check your release 'bearing?'
OP
Marvin Gruber
Yoda
Offline
Yes sir! Plenty of meat left. Clutch pressure plate weak, would not release. Apparently cheap aftermarket. Good clutch now. Releases a good 2" from floor.
Marv
Marv